Posts: 112
Threads: 36
Joined: May 2015
City: Brandon, SD
Was wondering if someone could tell me the correct chassis mounting washers along with the RF subchassis mounting washers for a 38-690? I see Renovated radios list them for 690/116, but dont know if that means 37/38-690...
Posts: 15,444
Threads: 539
Joined: Oct 2011
City: Jackson, NJ
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
(This post was last modified: 05-30-2019, 07:26 AM by
morzh.)
Posts: 112
Threads: 36
Joined: May 2015
City: Brandon, SD
What messed with me is they both say chassis support... so the 1st ones are what support the chassis in the cabinet, I’m assuming 4 of them, and the set of 3 are for the tuner sub-chassis that sets on the main chassis?
(This post was last modified: 05-30-2019, 09:47 AM by
sdradioman.)
Posts: 15,444
Threads: 539
Joined: Oct 2011
City: Jackson, NJ
To support the subchassis you need three - one rear and two sides.
There was also (haven't found it) a small grommet that goes in the tuning cap itself for the rotor support. But it is not for the chassis itself and you might or might not need it.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
Trivia - the 2 side supports are slightly different from the one in the back.
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Posts: 15,444
Threads: 539
Joined: Oct 2011
City: Jackson, NJ
Yes I think the back one has longer internal cylinder than the sides.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.