Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Unusual Crosley table radio
#1

I just picked up an unusual and rather large table radio built by Crosley today. I was so stunned when I saw it that I didn't even haggle the price! It's even bigger than my RCA 140 tombstone, but for a reason as it is a battery set. One of the best condition battery sets I have ever run across. Good cabinet, complete, and unmolested in any way. Even all the original battery leads are there, though I'll probably have to rework that if I ever go to power this set up. The chassis number and schematic number for this radio is 535 and the Crosley sites list this radio as the "Battery Fifty-Two". Other than that and the schmatics I found on nostalgia air, this radio draws a blank in my web searches so far. So, I wonder, did I get a real jewel or a lump of coal? Battery (farm) sets are always tricky and this thing is a monster of a table radio. Thankfully it doesn't weigh as much as the RCA 140! Icon_lol

No matter where you go, there you are.
#2

Neat Radio!!! Personally I often go after battery sets for the reason depicted by your Crosley. They are often in excellent original condition. The electronics are simple and usually one like yours will only require verifying that it is electrically sound. I do not recommend "jury-rigging" a power source for one unless you are VERY sound electrically, as DC voltage is inherently more dangerous than AC, and these battery sets draw a fair amount of DC current. (If im talking down to you, PLEASE forgive me.)
I recently aquired a Crosley 128 cathedral battery powered set. It is 3V A batt, 135V, 22.5V B batt, and after a mild rework, it WORKS !!!! It's an 8 tube model, with 2- 31 tubes as triode-pushpull output. NEAT set.
#3

Sounds like your voltages are the same as mine. Oddly, mine lists the 22.5 voltage as the 'C' battery. I was a bit miffed to find out all the tubes but one were totally burnt out. The other tube was a dead short. Managed to find replacements for them all today but the 1B5. Going to dig through the tubes I just got last week for that one. I'm wondering if the radio has a short or if someone connected too high of a battery to the 'A' supply.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>