Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Please ID Silvertone
#1

[Image: https://i.imgur.com/Xsqywgr.jpg]

Skip
#2

It's a King-Hinner set made for Silvertone. I have this one:
[Image: https://proxy.duckduckgo.com/iu/?u=http%...up.jpg&f=1]
Pic stolen from the net.
Don't know if there is a diagram for it but there is not must difference between most of the battery Neutrodyne TRF sets. This will get you in the ballpark: http://www.nostalgiaair.org/pagesbymodel...017930.pdf
The tricky part on this one is getting the chassis out. It comes out thru the front but you have to remove the wood trim to access the screws along the edge of the panel.

GLOM

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!

Terry
#3

Any Clue to what this is worth?

Skip
#4

Worth? Depending the market location 50-125 without tubes. add another 50 for a set of good '01a's. Knock off 50 if the audio transformers are bad and or not original...
Nice radio, I have a cabinet for one somewhere...

Chas

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently 1791 online users. [Complete List]
» 1 Member(s) | 1790 Guest(s)
Avatar

>