Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

General Electric 202 revived.
#16

So it really only juices up signal going to output? Not really making it more sensitive? Paul

Tubetalk1
#17

It's still a solid little radio from GE and as far as I can tell, is at least a little more sensitive than my comparable five tube radios from the same time period. I get it about the styling as it is different. I wasn't really into this model either until someone here mentioned that they are good performers. Usually these are beat up or high priced around my area, but this one was a bargain flea market find this past summer. Icon_wink

No matter where you go, there you are.
#18

Just a guess on my part, but I'd guess that while the set is more sensitive than an AA5, it likely is not more selective. Have a look at the 1950 Philco model 50-921, for a very good sounding, super sensitive and selective bakelite table model that has tuned a RF and a tuned mixer for two tuned RF stages versus one stage in most sets. It probably won't be cheap either, but I have owned one and used it, and they are very good performers in a package about the same size as the G.E.
#19

want a sensitive and selective set then look for a howard a300 .
#20

I am sure that GE 202 is a very nice sounding and sensitive set. I just found it odd that they'd add the extra tuned stage up front and not tune a stage that was already there.
#21

John that Philco sounds like a nice set to have around i will keep my eye open.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4663 online users. [Complete List]
» 4 Member(s) | 4659 Guest(s)
AvatarAvatarAvatarAvatar

>