Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help! Philco Model 48-1284
#1

    Good morning! I recently purchased this Philco and have some questions. I've never used a phonograph, and this one in particular, is very intimidating (I have very limited knowledge of Philco or phonographs). The radio works but the person that I purchased it from couldn't get the phonograph to work. Are there any troubleshooting suggestions? It might need replacement parts but I really don't want to go down that road. 

Thanks for your help!
#2

Hello Sammy. About all I can say is I have not run into one phonograph in the old radios that I did not have to do a good bit of work on to get them to play. Sometimes disassembly and thorough lube & cleaning will be all. But usually the cartridge or at least needle is bad, and if it uses one, the idler wheel that turns the platter is shot. Hopefully the motor is good.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM
Philco Predicta Siesta picture over time getting dimmer
I found that the wire insulation was burnt.  The fly back needs corona dope! Why would someone put that there?Platinumblonde36 — 01:09 AM
Philco Predicta Siesta picture over time getting dimmer
This is what it looked like beforePlatinumblonde36 — 01:01 AM
Philco Predicta Siesta picture over time getting dimmer
Platinumblonde36 — 12:58 AM
Philco Predicta Siesta picture over time getting dimmer
Platinumblonde36 — 12:57 AM
Philco Predicta Siesta picture over time getting dimmer
I'm finding some strange things in my set and for the most part it's also original, so I need to start going over everyt...Platinumblonde36 — 12:55 AM
12' Philco
Not anymore Mike. Andre The Giant Born: May 19, 1946, Coulommiers, France Died: Jan 28, 1993 (46 years), Paris, Fran...RodB — 11:53 PM
IF can wire size and Rubber mounts?
Renovated Radios do carry what you need. As for the voltage, a wire should be at least 300V-rated.morzh — 11:13 PM

[-]
Who's Online
There are currently 3211 online users. [Complete List]
» 1 Member(s) | 3210 Guest(s)
Avatar

>