Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Lafayette HE-30
#16

Very nice looking set Mike and I really like the dial, but how is the bottom half (logging) used?

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#17

John, the bottom half are spread bands for the ham frequencies, just as the second spread band dial is on a Hammarlund. In this receiver, you set the lower pointer to the "set" position,which is at the high end of each of the ham bands. Then you tune the radio so that the pointer of the top, main tuning section of the fial is at the high end of the particular ham band you wish to listen to. Then you tune down the band using the bandspread lower pointer and lower half of the dial. If you look carefully at the picture I posted at the beginning of this thread, showing the front of the radio clearly, you will see the markings on both the lower and upper half of the dial, and the two pointers, which may make my explanation clearer.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2937 online users. [Complete List]
» 3 Member(s) | 2934 Guest(s)
AvatarAvatarAvatar

>