Posts: 7,248
Threads: 266
Joined: Dec 2009
City: Roslyn Pa
With it misbehaving touch the grid cap of the 78 rf amp and then the 77 mixer tube. Does that stop the noise?
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Posts: 751
Threads: 91
Joined: Nov 2015
City: Jonesboro
State, Province, Country: AR
I tried as suggested. It didn’t seem to make a difference, other than completely killing the entire signal when I touched one of the tubes.
So, I plugged in and ran 3 different radios, including a more modern (1970s-80s) unit. Apparently the signal I’m getting is something new to either the house or area.
![Icon_evil Icon_evil](https://philcoradio.com/phorum/images/smilies/icon_evil.gif)
I wasn’t getting it earlier (a few weeks ago), so I thought it was specific to this recent restore. It’s not specific. It is affecting my other radios in the same frequency spread. So that resolves this problem.
Blessings,
Jeff W.
Jonesboro, Arkansas
http://jeffsradios.weebly.com
God loves you as you are, not as you should be, because none of us are as we should be. - Brennan Manning
Posts: 102
Threads: 14
Joined: Jul 2017
City: Bakersfield, CA
The final test will be when I get the 16 home and try it. My guess, there is a transformer or some such device near Jeff that it splattering out a spurious signal. I've seen that same sort of thing happen on the ham band. We'll see! Thanks for your hard work, Jeff!!