Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Did Philco Make a Good AM-FM Table Radio?
#1

I thought I would ask this seeing as I now have a couple good Zeniths and finally have a good RCA AM-FM table radio in my stable. Did Philco make a good AM-FM table radio and what model would it be? So far I have only seen small units in poor shape around here, so the jury is out on that for me. It seems odd to have two of what I consider the original 'Big Three' of radio sales represented without a Philco example.

No matter where you go, there you are.
#2

Well I guess it depends on what year you're interested in. The first table model with FM is one of the best, the 48-482. A huge beast, basically a console in a table model. Has AM/FM and short wave.

Greg V.
West Bend, WI
Member WARCI.org
#3

Year doesn't really matter here, just in the tube era I would say. I have seen a few 48-482's in my area over the years, but they are usually trashed like most other late 40's Philcos are that I find around here. Also, it seems people's pets and kids loved to rip out both the grill cloth and the speaker cones in units I see.

No matter where you go, there you are.
#4

The 48-482 I restored had a great sound. Gave it away as a gift.
#5

       
I would vote for Philco model 53-956  my only Philco AM FM. Found at the local flea market summer of 2011.
#6

I have often been leery of FM Philco due to their reluctance to pay for the "Armsrong System".

Paul

Tubetalk1
#7

Thanks for the advice thus far. I almost bought a model 53-956 a few years back, but was a bit hesitant at the time and missed out. I was looking at a nice condition 49-906 with a bad cord today, but am trying to research that one first. I have a big Philco AM-FM and it's matching console from 1948 that both use two 117Z3 rectifier tubes. The console is fair, but tries to play and the table unit has a livable cabinet, but the best way to describe the inside is 'bio-hazard'. Some critters made a mess in there! In spite of that, it tried to power up and I got a little audio out of it. Not sure what to do with those two.

Edit: They are 1949 models. The table 'bio hazard' one is a 49-909 and the console is either a 49-1100 or 49-1101. Had them for a while.

No matter where you go, there you are.
#8

Maybe clean out the old nest, and then give it a check up. Paul

Tubetalk1
#9

There's no nest, just plenty of droppings... Chassis isn't too bad, but the screws that hold the chassis in on one side are totally rusted. If I could get it out I MIGHT have a chance to clean out the cabinet and chassis. I don't think it was mice that left the crap in this radio, it almost looks like from birds or other critters.

No matter where you go, there you are.
#10

Wear a mask and gloves, wipe it out with alchohol on a rag or such. Be careful.

Paul

Tubetalk1




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently no members online.

>