Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

here is another one i need to id philco
#1

i was told this is a philco 38-116 but it has a different cabinet than the one i have and can i get repo speaker cloth for this 
benny


Attached Files Image(s)
       
#2

I can tell you one thing it isn't that's a 38-116 chassis or cabinet. Will shoot for 38-2.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

I think Terry is right. I have one like it that i have not looked at in along time. My 38-116 is NOT like that!
#4

Just take a look through the Philco Radio Gallery.

https://philcoradio.com/gallery2/1938a/#Model_38-2XX

Whoomp, there it is.

--
Ron Ramirez
Ferdinand IN
#5

Yes but did it have the wide chevron grille cloth?

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#6

The 38-2 used the Philco "Ribbed" pattern originally, mounted vertically (up and down). Not the chevron cloth.

--
Ron Ramirez
Ferdinand IN
#7

is anyone making repo speaker cloth
#8

Radio Daze lists their GRC14 which is not exactly like the original, but is the best you can do now.

https://www.radiodaze.com/grille-cloth-14-item-grc14/

--
Ron Ramirez
Ferdinand IN
#9

thank you Ron i have been reading about the 38-690 you have worked on these radios are more complex to work on but i am very impressed with the reception they get when finished my very first try at one of these is the philco 38-116  
benny




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>