Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

decals
#1

i havent used decals since the early sixties. i dont consider myself hamfisted or an uncoordinated oaf either. however i met my match trying to install ONE "philco" on the front of my 48-482. i had 4 shots one was damaged from the get go and the others i broke one by one trying to either slide them off the paper in one piece or maneuvering them into position. i dont remember if i got them from radio daze or not but they were about five years old. i MUST be doing something wrong. if this is the norm ill need hundreds to get the five need done. i can appreciate the need for them to be thin but these had zero strength. PLEASE enlighten me!
#2

I always try to apply them on a wet horizontal surface, if possible, and if they don't slip easily off the backing paper, I'll soak them for a while longer.

But you are right: they seem to deteriorate after a few years, and break apart easily.
#3

I agree, decals become more fragile as they get older. Order new ones, you will have better luck. Also, when installing them, use an artist paint brush to maneuver decal and remove excess water.

Steve

M R Radios   C M Tubes




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2971 online users. [Complete List]
» 2 Member(s) | 2969 Guest(s)
AvatarAvatar

>