Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-605 Squeal/Motorboat
#1

I'm working on a 41-605, replaced the obligatory caps as well as some dominos, out of spec resistors, checked tubes, general socket and pot cleanups, etc. The AM side plays fine up to about 1400 where the oscillator starts the infamous squeal and motorboating right up thru the top of the dial. All good below 1400. The SW side works fine with no issues. I have it isolated to most likely issues with the oscillator circuit. A NOS 14AF7/XXD didn't help. Resistance specs of the oscillator coil are good. I've maneuvered lead and component placement as much as I dare in the oscillator area around the XXD. Oscillator padder 17A does impact the intensity but doesn't eliminate it. Can anyone offer any suggestions or hints as to what I may have missed?

Much appreciated.

Gary
WB9AYD
#2

Are all tube shields on?
#3

These are Loctals and I cleaned all of the tubes and sockets.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM
Zenith H725
Ed; One material that I have seen, but never tried for this was material for making exhaust gaskets, it's similar to ...Arran — 11:42 PM
Zenith H725
I just remembered, I have some hi temp silicone rubber material which could do the trick. Or a piece of FR4 laminate. Th...EdHolland — 08:39 PM
Zenith H725
The PSU filter cap arrived today (thank you USPS!) so I will work on that later. Meanwhile, I have the dial, speaker...EdHolland — 06:42 PM
Philco 610B oscillator wiring
Thanks Terry. After checking my notes I think I recorded about -10v at the 6A7 G4/control grid. The screen grid (G3 &...Tubester — 05:59 PM

[-]
Who's Online
There are currently 2405 online users. [Complete List]
» 2 Member(s) | 2403 Guest(s)
AvatarAvatar

>