1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
46-1203 Turn Table.
Mikey
New Member
*
Posts: 2
Threads: 1
Joined: Oct 2021
City: Christiansburg State, Province, Country: Virginia
#1

11-01-2021, 05:46 AM
Greetings. I'm a newbie to the forum. I'm working on my first restoration of a model 46-1203. Ive got the turn table rotating but the auto changer isn't working. I'm in the process of taking apart and cleaning all the mechanisms. I've noticed that the black piece next to the tone arm is fairly bent. I was wondering if this is by design or damaged. Any other info would be great. Thanks. Mikey    
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#2

11-01-2021, 10:34 AM
Hi Mikey and welcome,
The best I can do for you is to give you a link to the service manual for the turntable. https://philcoradio.com/library/download...6-1947.pdf  Not much of a tt guy myself.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
(This post was last modified: 11-01-2021, 10:35 AM by Radioroslyn.)
Find
Mikey
New Member
*
Posts: 2
Threads: 1
Joined: Oct 2021
City: Christiansburg State, Province, Country: Virginia
#3

11-01-2021, 01:23 PM
Thank you. Service manual will be valuable aligning everything back up. I missed it when I was going thru the litature list. Thanks again. Mikey
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4218 online users. [Complete List]
» 1 Member(s) | 4217 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration