Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PHilco 44
#1

Hello my ingles is bad, sorry i'm spanish.
i look for pictures of Philco 44, box and chassis, because i need this picture for restoration of my radio.
i think that is one radio Philco 44, is there some box this model ?
thank you, Mauricio
#2

Here is a picture of the 1934 Model 44 Philco:

[Image: http://radioatticarchives.com/images/p/P..._KBoyd.jpg]
#3

is there other box of model Philco 44 ??
because if you put philco 44, is this the model Philco 44 ????

http://www.wjoe.com/philco441.jpg
#4

This picture above is the Model 44B, which means the Baby Grand cathedral cabinet.

The Model 44 also came in the High Boy cabinet as
the Model 44H

[Image: http://www.philcorepairbench.com/images/44H.jpg]


and the console version Model 44X. The X stands for an inclined speaker sound board.


[Image: http://www.philcorepairbench.com/images/44X.jpg]
#5

hello again, have you pictures of chassis philco 44b
one cuestions have the philco 34 the same box that philco 44B
thank you, Mauricio
#6

No pictures of the Model 44 chassis, only the pictures above.

The Model 34 came in different cabinets - see below.

The Baby Grand case is a flat front with no raised moulding like the 44.


[Image: http://www.philcorepairbench.com/images/34B.jpg]


[Image: http://www.philcorepairbench.com/images/34L.jpg]
#7

thank you,, have you any pictures of chassis 34b ?
because i have one radio, i think that is is 34b o 44b, but i don´t
#8

No, sorry, no pictures of chassis'.

But you can use the TUBE MANUAL section of my website to help identify the chassis you have. Use the tube socket layout diagrams there to see what matches the tubes and locations on the chassis.
#9

Mauricio
Email me at lawnweeds100@yahoo.com and I will send picture of Philco 44 Chassis; it uses 110 volts AC, 2 prong plug. A Model 34 will not have a power transformer and will have a battery cable. -Pedro alias-

Pete AI2V




Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6353 online users. [Complete List]
» 2 Member(s) | 6351 Guest(s)
AvatarAvatar

>