Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Canadian KL96 console restored
#1

A friend of mine gave me this radio  because he had it given to him ,and he does not collect radios.
        During the last winter I recapped the chassis and it plays very good.
  I just finished the cabinet, and it came out pretty good.    There was enough of the original colors left
to figure out where it should be darker.
After I installed the chassis the push buttons would not work.so I took everything out of the cabinet and set it on the bench.

   It turn out that there are three wires coming from the chassis  to the push buttons besides the three prong plug that goes to the chassis
Those wires come from the bottom of the chassis, so I missed them.  it is all good now.
 Here are some photos.
 Dan in Calgary


Attached Files Image(s)
                           

   Living in Calgary Alberta
#2

Very Nice!
Icon_thumbup Icon_thumbup Icon_thumbup
#3

I agree; I like the large knobs and the coloring....
#4

Looks great! Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently 2036 online users. [Complete List]
» 2 Member(s) | 2034 Guest(s)
AvatarAvatar

>