Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

need schematic for knight console
#1

trying to troubleshoot an 8 tube knight console, tag inside says model 21-c but I cannot find any model close to it. it is 3 band short, med., brdcst 4 knob with 6 pushbuttons, on off-tone, band-pushbutton, volume, tune. tube line up is 5y3, 6sj7, 6sa7, 6sk7, 6sq7, 6sf5, and 2-6k6. It has been recapped before but has apparently not worked since that repair, trans, rect. voltages correct but to hot on grids of both output tubes with no sound. without schematic Im not sure if replaced caps were connected in proper spot. I am a learning amature and can only restore step by step through the schematic. any info will be appriciated.
#2

Try this Sentinel schematic:

http://www.nostalgiaair.org/PagesByModel...018088.pdf

Carl
Northern Panhandle, WV




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 3980 online users. [Complete List]
» 1 Member(s) | 3979 Guest(s)
Avatar

>