Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A-361 radio
#1

Hi! I am new to the phorum.  I am looking for schematics for an 1942 A-361 Philco radio in a floor model cabinet.  The tuner string is broken and we would like to replace it and need to know how to correctly restring it.  Any help is appreciated!
Martha
#2

Hi Martha, and welcome.

You can find the service information for model A361 here:

https://philcoradio.com/library/download...20Book.pdf

Unfortunately, this does not include a dial stringing diagram.

The radio chassis is basically the same as the F-1942 auto radio, modified to operate on 110-115 volts AC. However, its service data also does not include a dial stringing guide.

https://philcoradio.com/library/download...20Book.pdf

There was a Dial Cord Stringing Guide published by Howard W. Sams & Company in 1947, but it does not include the A361 or the F-1942.

Judging from your location, there are two radio clubs near you - the Mid-America Antique Radio Club in Kansas City, and the Oklahoma Vintage Radio Collectors in Oklahoma City. Perhaps one of these clubs might be able to help? The club in KC has no website but has a Facebook page:
https://www.facebook.com/maarckc/

and OKVRC's website is:
http://okvrc.org/

Good luck, and sorry I could not help with a dial stringing diagram.

If there is anyone else here who knows this information, please share it in this thread.

--
Ron Ramirez
Ferdinand IN
#3

Hi and welcome,

Perhaps this will be a help: https://www.youtube.com/watch?v=65UTJP8w...iveOhSeven

After perusing the schematic I would get rid of 65 and 66. If they are leaky or short it will take out the power transformer in short order. I suspect it's a throw back from the car radio design using a vibrator. In that circuit it helps saves the contacts therein. They are unnecessary.

GL with your project!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

Great find, Terry - thanks for sharing! Icon_thumbup

--
Ron Ramirez
Ferdinand IN
#5

Just downloaded thanks.
#6

Thank you Ron, for the response!  I will follow up on your suggestions.  I have already tried the Kansas City site but didn't have any luck.  I took it up to someone up there to look at but since it has the car radio in it, as it should, they weren't able to fix it.  I didn't see any reference to a club in OKC, so I will look them up!  Thank you for the help! Martha




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM

[-]
Who's Online
There are currently no members online.

>