Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A-361 radio
#1
Sad 

I had sent out my husband's A-361 radio  for repair and have since learned that the glass tuning dial was mistakenly discarded.  If anyone knows of where I might get another one, I would be very grateful.  I can't say how disheartening this is.
Thank you,
Martha
#2

There is a A-361 on Craigslist in Onalaska Wisconsin for 50 bucks. You could always inquire if they want to part it out. Good luck
Jim
#3

Three possibilities that I can think of for you.
1) Put a Wanted Ad in the Phorum Wanted Ad section. Its not likely but possible that someone has one in their boxes of miscellaneous repair parts.
2) Watch Ebay for sales of A361 radios for a donor dial glass.
3) You can contact the folks at RadioDaze and talk to them about custom making a dial glass for you. https://www.radiodaze.com/contact/
That may require you to have a dial glass on loan for them to copy but I'm not sure about that. I have purchased dial glass from them but they were not custom made for me.

Other folks may have some other ideas for you. Good luck.
#4

Thank you for the suggestions! I so appreciate the knowledge and support on the Phorum. I will try them out!
Warm regards,
Martha




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM

[-]
Who's Online
There are currently 1641 online users. [Complete List]
» 1 Member(s) | 1640 Guest(s)
Avatar

>