1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
info for aligning philco recivers
mg34.42
Member
***
Posts: 88
Threads: 35
Joined: Dec 2013
City: Tulsa, OK
#1

03-14-2023, 11:37 PM
i have been told that there is a mistake in the origanl alignment insructions for the philco 90 with one 47 tube tube can some one set me striraight on this i would also love to find an origanal copy of the philco aligment most of the down loads are hard to read 
benny
Find
462ron
Phorum Expert
*****
Posts: 813
Threads: 49
Joined: Feb 2013
City: Shenandoah, State, Province, Country: Pennsylvania
#2

03-15-2023, 08:29 AM
Benny I found this in the Philco Library under Shop Talk model notes …
https://philcoradio.com/library/index.ph...-model-90/

https://philcoradio.com/library/wp-conte...Vol.-1.pdf

Ron
Bendix 0626.      RCA 8BX5.   RCA T64
Philco 41-250.    Philco49-500
GE 201.             Philco 39-25
Motorola 61X13. Philco 46-42        Crosley 52TQ
Philco 37-116.    Philco 70
AK 35                Philco 46-350
Philco 620B.       Zenith Transoceanic B-600
Philco 60B.         Majestic 50
Philco 52-944.    AK 84
(This post was last modified: 03-15-2023, 08:41 AM by 462ron.)
Find
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#3

03-15-2023, 08:41 AM
As 462ron said, it's 175 kc.

The correct alignment info may be found in the book Aligning Philco Receivers, Volume 1 by John F. Rider. A copy may be found in the Philco Phorum's Library:

https://philcoradio.com/library/index.ph...ers-vol-i/

The alignment info is on page 84 of the book (page 128 of the PDF file).
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6745 online users. [Complete List]
» 2 Member(s) | 6743 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration