Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Antennas
#1

Hi guys. I've been MIA for a few years, moving house a couple times among other significant events keeping me from this hobby.

I listened to my Model 20 a fair amount during 2020 while working from home until the power stopped working. I finally had a look and discovered a poor original wire from the power switch. Replaced and it's back in business (except for an issue of occasional good signal that becomes poor and drops as the set warms up over a couple minutes. My original thought was a hot tube issue, but will start looking into it more this spring).

Now that I'm settled in a house, I'm thinking of improved reception for my radios. What do you guys think of a roof aerial or something mounted in the attic? I've used an assortment of plain wire antennas over the years that have been "ok", but would like better performance overall. I'm about 30 miles southwest of Chicago and can pick up a couple stations pretty well, but not much else. I'd like to listen to something besides the ballgame and political talk radio.

Greg

"We are here to laugh at the odds and live our lives so well that Death will tremble to take us."
#2

Quote:I'm thinking of improved reception for my radios. What do you guys think of a roof aerial or something mounted in the attic?
Good idea Icon_biggrin 

Give it a good ground too, short and direct to earth, not the ground for the wall outlet...

Chas

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”
#3

Quote:Give it a good ground too, short and direct to earth, not the ground for the wall outlet...

I figured I'd run a long wire to the basement and ground it to the water main from the city. It's copper and certainly underground!

Greg

"We are here to laugh at the odds and live our lives so well that Death will tremble to take us."
#4

Hi Greg, as for an antenna, I’ve had great results using my landline phone line. In most homes, there are 4 wires in the line coming in. 2 of them are fore the phone and the other 2 have nothing on them. I hooked a .001mfd cap to either one of those and run a wire to my radio. That gets me about 60’ or more of antenna running from the house, up high and out to the pole on the street plus the extra footage run throughout the house. And now since we’ve done away with our home phone, I can put my radio in any room in the house and have access to that antenna from any phone Jack.

Ron

Bendix 0626.      RCA 8BX5.   RCA T64
Philco 41-250.    Philco49-500
GE 201.             Philco 39-25
Motorola 61X13. Philco 46-42        Crosley 52TQ
Philco 37-116.    Philco 70
AK 35                Philco 46-350
Philco 620B.       Zenith Transoceanic B-600
Philco 60B.         Majestic 50
Philco 52-944.    AK 84




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently no members online.

>