Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco radio with phono input
#1

Does anyone know if Philco made a radio with a phono input?  In the 50’s I had a record changer with crystal cartridge and what I seem to remember is a Philco radio
with a phono jack. Radio long gone, but I still have the changer. They were a present from an older brother, along with a stack of children’s records. 
Thanks
Thom.
#2

Hi Thom,

Hmmm...the only Philcos I can think of offhand with a phono input are Philco Tropic radios, along with one domestic model which is basically part of the Tropic family - model 53-960. That is a rather large radio, however. I'm guessing the set you had was smaller?

--
Ron Ramirez
Ferdinand IN
#3

The radio I remember was a smaller one in a vertical cream plastic case. Phono jack was on the right side looking at the front. This was over 60 years ago, so might not have been a Philco.
Thom.
#4

They were adding phono inputs optionally without them being on the original schematic. Don't ask me how I know.
#5

I can't remember if it was a Philco or an Emerson, but I fixed one that had an RCA style phono jack on the right side. On this model, when you plugged the phono into this jack, the radio would be disconnected, much like a headphone jack does.

I have 2 Zenith AM FM H7XX models, an RCA 1R81 and 2 GEs, all with RA Phone Jacks. Most have radio / phono switches. the 2GEs are mid 50s clock radios. Turning the volume pot CW makes the radio louder and the phono lower, turning it CCW makes the radio lower, and the phono input louder.

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
Best Regards, 

MrFixr55
#6

I've seen some Canadian Philco models with an RCA phono jack, but those were at the rear, not in the side of the cabinet. It really depends on what model in what year, the ones that were clones of U.S Philcos did not have them, except for the Philco Tropic clones, my Bing Crosby does not. 
Regards
Arran




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 5416 online users. [Complete List]
» 1 Member(s) | 5415 Guest(s)
Avatar

>