Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Pioneer SX-750
#1

Hi Folks,

Not sure whether to post this here, or in August Phinds, but it is audio gear, and solid state. However, hailing from 1976, or thereabouts, it definitely counts as classic in some form or other. Apart from a gentle clean of the front panel, I've done nothing except power on. It certainly receives, and may have one blown indicator light, for FM (perhaps not surprising). 

Very much in the classic receiver heyday style, there is a beautiful illuminated silver front panel, two large meters for signal strength and tuning, and a heavy flywheel on the tuning control. The power amp sports 50 Watts/channel. Not sure what I'll do with it yet, but we'll find a spot.

Ed

I don't hold with furniture that talks.
#2

Ed;
  According to Jordan Pier if it has Matsushita caps of the blue purple colour replace them on site, they are notorious for leaking electrolyte. Elna brand caps don't but they do dry out and go open. I'm not sure if Pioneer stuff uses either of those.
Regards
Arran
#3

Arran, thanks, I will look at that.

Several Ebay sources offer cap kits, if I'm feeling lazy,

Ed

I don't hold with furniture that talks.
#4

Hello Arran,
I agree Matsushita caps are just plan junk !

Sincerely Richard




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently no members online.

>