Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Pioneer SX-750
#1

Hi Folks,

Not sure whether to post this here, or in August Phinds, but it is audio gear, and solid state. However, hailing from 1976, or thereabouts, it definitely counts as classic in some form or other. Apart from a gentle clean of the front panel, I've done nothing except power on. It certainly receives, and may have one blown indicator light, for FM (perhaps not surprising). 

Very much in the classic receiver heyday style, there is a beautiful illuminated silver front panel, two large meters for signal strength and tuning, and a heavy flywheel on the tuning control. The power amp sports 50 Watts/channel. Not sure what I'll do with it yet, but we'll find a spot.

Ed

I don't hold with furniture that talks.
#2

Ed;
  According to Jordan Pier if it has Matsushita caps of the blue purple colour replace them on site, they are notorious for leaking electrolyte. Elna brand caps don't but they do dry out and go open. I'm not sure if Pioneer stuff uses either of those.
Regards
Arran
#3

Arran, thanks, I will look at that.

Several Ebay sources offer cap kits, if I'm feeling lazy,

Ed

I don't hold with furniture that talks.
#4

Hello Arran,
I agree Matsushita caps are just plan junk !

Sincerely Richard




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM

[-]
Who's Online
There are currently 1024 online users. [Complete List]
» 1 Member(s) | 1023 Guest(s)
Avatar

>