Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-165 vs 41-260
#1

Today I was reading the classifieds in our local paper to find a Philco console radio for sale for $100. Curious, I called on the radio and inquired as to what model it was. The seller checked and said it is a 41-260 that is in good shape and working. Guess his wife got it and is now not in love with it anymore. Anyways, I wasn't sure I wanted it because I have a nice 40-165 that works well and really both look to be the same radio except that the cabinet on the 41-260 might be a bit different and it appears to be a 7 tube chassis. Was one radio better than the other or is the performance the same?

No matter where you go, there you are.
#2

Hi Jayce
The sets are pretty similar but the '165 has a rf amp before the mixer, but the '260 has no rf amp but two IF amps
So the '165 should pickup more stations (has more front end gain) but can't separate them apart where the '260 should be able to separate them better (better selectivity because of more IF gain).
Audio looks to be the same. I'd say it's a toss up.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Ok. Thanks for helping me sort that out. My little 40-165 is actually great at receiving stations and is sometimes the only radio in my collection that can sort our local station out of the background noise at night when they turn the power down. I did take down the info on the 41-260 and figure I can pass the info on if anything else. It's hard to sell old radios around here, so I wish the guy luck.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3976 online users. [Complete List]
» 1 Member(s) | 3975 Guest(s)
Avatar

>