Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My latest restoration Sony TR-610
#1

Hello Everyone,
Here is my latest restoration My little Sony transistor radio model TR-610 from 1958.
I had replace what I consider to be the smallest multi-section electrolytic capacitor this little tiny capacitor contains three 20 ufd at 10volts .
the one thing I have to do is to adjust some trimmers on the tuning capacitor because I noticed the factory seal was broken but the IF cans are still sealed .

Sincerely Richard
P.S. I will post a photo of the capacitor too.


Attached Files Image(s)
   
#2

Rich


They forgot to add the word "whopping" in front of the "six transistors" Icon_lol

Multi-section cap...wow, have never seen one in small transistor jobs. Do you have photos?

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#3

Hello morzh,
Here you go the capacitor is 1/2 tall and like 3/8 inch in diameter .

Sincerely richard


Attached Files Image(s)
   
#4

Nippon Chemicon made I think, probably constructed like a jelly roll inside, much like a multi section twist lock can.
Regards
Arran
#5

Hello Arran,
Yes , I am sure it is a Nippon Chemicon made capacitor !

Sincerely Richard




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM

[-]
Who's Online
There are currently 7764 online users. [Complete List]
» 2 Member(s) | 7762 Guest(s)
AvatarAvatar

>