Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 29 or 45
#1

Hello, I have just received a Philco lowboy where the tube layout label in the cabinet says 29 or 45. There is no label or markings on the chassis to say which it is. Is there some way to tell what I have? Also my search for a new dial came up empty on Radio Daze does anyone know if I can get one?

Thanks,
Dan
#2

29 chassis has a shadow meter while 45 chassis does not. Shadow meter is part no. 27 in the 29 schematic. compare it to the 45 chassis.
https://philcoradio.com/library/index.ph...ams-vol-1/

...and here's a series of discussions that Ron Ramirez did about his 29/45 restoration. This the link to Part 1 of 7.
https://philcoradio.com/library/index.ph...on-part-1/
#3

Thanks for the info Bob. Looks like a have a 45 (no shadow). Stuffing old paper caps is a bit more than what I care to do. Besides who will ever see them. I restuff electrolytic caps if there is no room under the chassis otherwise I leave the old ones in place disconnected.

Dan




Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently no members online.

>