Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-1226 Code 122 Schematic
#1

Hello all,

I'm in the midst of restoring a 46-1226 Code 122. I have obtained several schematics - Riders, Philco service manual, but the problem is these all deal with the code 121 model, or if they address 122, it's just to list the changes that were made.

Problem is, this model had a rather large change, with the 7F8 converter replaced by a 7AF7, and with it, the wiring and circuity was altered quite a bit.

I'm in need of a schematic for the Code 122. I found one through the Radio Museum, but the quality is poor; almost bordering on illegible.

Does anyone have a fairly high resolution, clean image scan of the schematic? I'd very much appreciate any help.

Thanks!

BR
#2

Welcome to the Phorum, BR! Someone here should have the info you're looking for. Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#3

Hello,
If you click on the PHILCO LIBRARY tab on the banner at the top of this site, then click on the SERVICE INFO tab it will take you to the Philco Service section (a drop-down menu).
Select the 1946 - 1947 Home Radio Year Book. Under the table of Contents you will find a link to the model 46 - 1226. This will provide all the published info from Philco for that model. The information includes pages 214 - 224 from the yearbook. The last page is a schematic for the 46-1226 code 122.
It appears to be a good clear copy.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 70 antenna lead
Jim If you mean the wire going from the Volume pot to the back, here It does not seem to run ovefr those. Quite t...morzh — 02:21 PM
Philco 70 antenna lead
Seems odd to me that Philco would run the antenna lead over top of the filter caps and the power cord. Would that not in...Jim Dutridge — 01:54 PM
Custom Hammond Power Transformer
Joseph, Very well done! Because the radio has some chassis corrosion, do solder or re-solder all chassis connecti...Chas — 12:50 PM
Philco 60 restoration
Arran The control is original. The wiper is some sort of round brass plate, that probably just digs into the carbon e...morzh — 12:28 PM
Model 41-280 5 dials
Have fun. This is my thread on that same radio. Bought in 2014, restored in 2017. Be prepared to deal with rubb...morzh — 12:24 PM
My first Philco radio.
Boy this party ready DIEDOldie Goldie — 12:01 PM
Model 41-280 5 dials
Welcome to the Phorum, blake3801! The right four knobs are correct for this set. The fifth knob on the left is an add-...GarySP — 10:34 AM
Model 41-280 5 dials
Hey everyone, new to the classic radio game. I’m being gifted a Model 41-280 from the in-laws, and from what I’ve seen o...blake3801 — 01:40 AM
Philco 60 restoration
Mike; So if you check the resistance from end to end the volume pot reads 3 meg Ohm? I could see 1 meg maybe, if some...Arran — 11:59 PM
40-180 electrical troubleshooting
I isolated the circuit. And I’m still blowing 60 resistor. I just ordered the 84 rectifier tube. To see if that’s the is...winamp920@yahoo.com — 10:58 PM

[-]
Who's Online
There are currently 3409 online users. [Complete List]
» 1 Member(s) | 3408 Guest(s)
Avatar

>