Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 316 schematic needed
#1

I recently received a Philco 316 code 126 radio. It was manufactured in Toronto so it’s a Canadian model. I did find one schematic on Nostalgia Air but it’s very fuzzy and hard to make out the values for the caps and resistors. It also doesn't contain a parts list which I find very helpful since I’m relatively new to this hobby.

Does anyone have a better copy of this schematic or possibly a parts list that they could post, or is there a US model that is the same as the Canadian model?

Appreciate any assistance.
#2

If it's the set I think it is the U.S model is a model 16, but then again there is typically a Code number as well as a model number. The 316 should be in the RCC manuals, which I think the radiocodegods site has, I don't think Pacifictv has Philco models, here are some better diagrams of the U.S versions on this site https://philcoradio.com/library/index.ph...ams-vol-1/

Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 70 antenna lead
Seems odd to me that Philco would run the antenna lead over top of the filter caps and the power cord. Would that not in...Jim Dutridge — 01:54 PM
Custom Hammond Power Transformer
Joseph, Very well done! Because the radio has some chassis corrosion, do solder or re-solder all chassis connecti...Chas — 12:50 PM
Philco 60 restoration
Arran The control is original. The wiper is some sort of round brass plate, that probably just digs into the carbon e...morzh — 12:28 PM
Model 41-280 5 dials
Have fun. This is my thread on that same radio. Bought in 2014, restored in 2017. Be prepared to deal with rubb...morzh — 12:24 PM
My first Philco radio.
Boy this party ready DIEDOldie Goldie — 12:01 PM
Model 41-280 5 dials
Welcome to the Phorum, blake3801! The right four knobs are correct for this set. The fifth knob on the left is an add-...GarySP — 10:34 AM
Model 41-280 5 dials
Hey everyone, new to the classic radio game. I’m being gifted a Model 41-280 from the in-laws, and from what I’ve seen o...blake3801 — 01:40 AM
Philco 60 restoration
Mike; So if you check the resistance from end to end the volume pot reads 3 meg Ohm? I could see 1 meg maybe, if some...Arran — 11:59 PM
40-180 electrical troubleshooting
I isolated the circuit. And I’m still blowing 60 resistor. I just ordered the 84 rectifier tube. To see if that’s the is...winamp920@yahoo.com — 10:58 PM
Philco 60 restoration
After having attached the line cord, I checked the switch and the volume pot again. That is, I did check the switch befo...morzh — 10:34 PM

[-]
Who's Online
There are currently 3420 online users. [Complete List]
» 1 Member(s) | 3419 Guest(s)
Avatar

>