[morzh]

Because the usable power rating of it then is (3,200/20,000)*25W= 4W.
Maybe a tad more due to the mass, but not much. You are not using the full resistor.

[dconant]

I wondered about that. Wish there was some place local to get this stuff.

[dconant]

The shadow meter in the radio is responding to tuned signals but it never goes to a very small shadow even on strong signals. Best I can get is about a 3/8 of an inch. Is that about right or should it get narrower? The 1k resistor (#14) has been replaced. Would altering the value of #14 make any difference if so higher or lower?

Also I can't get he lower end of the dial completely lined up. Off about 10kc. The low frequency compensator (#23) is turned out to where it is no longer making a difference. There is a 410pf mica (#24) across the compensator. Could that be a problem and maybe replace it with a different value. The dial is reading higher than the 10kc higher than it should. The high side is spot on.

Thanks,
Dan

[morzh]

410pF is a large capacitance to parallel to a compensator.

As for the shadowmeter....yes, 3/8" is a bit wide, but then it also depends on the station's strength.
Does it go narrower than that when fed a signal from a generator?

[dconant]

The width does not get narrower with generator.

I think I will try some other cap values.

[morzh]

If it does not get narrower with strong signal and your AVC is OK, it could veru well be that the shadowgraph's magnet is a bit weak. Not the end of the world, not even that important: I tune by ear and the shadowgraph is for show and tell mostly.