[jrblasde]

I decided to commit to buying the other 46-480. $75 isn’t terrible, considering that they’ll be traveling through Oklahoma on a vacation in a few weeks and I can meet them to get it at a town about an hour and 15 minutes west of Tulsa. Saves me from driving up near Kansas City where it is now.

I reached back out to the guy I saw on the Philco Radio Enthusiasts page, and I think he’s interested in the output transformer from this set. He asked what I’d sell it for, and I said $20. We’ll see if he accepts. I’m not looking to get rich off of these parts. I’d rather know that they are going to be used by someone looking for that last crucial component.

Once I have the console, I’ll create a listing here with all of the parts which are available. Based upon the photos, the chassis looks clean. The cabinet is in serious need of refinishing, but it looks solid.

[Arran]

Is the chassis in the parts set less rusty then the one you have been working on or about the same?

[jrblasde]

The donor chassis looks pretty good, based on the photo I saw.

[morzh]

Donors always look good. Until they are out of their kidneys...

[jrblasde]

Hahaha, very true! In any event, the photo didn’t show any substantial rust on the top side of the chassis. It also clearly displayed the IF transformer for which I’ve been searching.

I’ll get you all some better information once I have it in my possession.

[GarySP]

Hope the IF transformer is intact! Good luck! - Gary

[jrblasde]

Good afternoon, folks! A wind of good luck has come! I’ve been quietly waiting to go get the junker 46-480, but I’ve just gotten an email from Mark Oppat. After a couple of months of looking, he found the IF can I need! He had me fill out an order form, and now he’ll ship it to me. I am thrilled!

Aside from that, here’s my progress. I’ve kept at it, but have slowed down a bit lately while I repaint the exterior of my house. I’d estimate that I am about 2/3 of the way done reassembling.

   

   

   

[jrblasde]

I forgot to make mention of it the other day, but last week I corrected another error on my schematic (applies to both Revs 0 and 1). I had thought, from looking at the Philco schematic, that pins 4 and 6 of the 7H7 used as the second IF amp were connected. I realized when comparing against my physical wiring notes that they are not. I also verified using the Rider's version of the schematic that they are not tied together. I'm sure that the original Philco schematic was correct, but this particular crossing was blurry and it looked to me to be a node. Anyway, I've attached the corrected schematics.

Before Correction:
   

After Correction:
   

[morzh]

I have never hear of the Suppressor Grid to be used in parallel with the Grid.
SG sole purpose is to be anti-dynatron grid, which is suppressing the secondary emission.
Which usually makes it connecting to GND or K.