Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Refinishing Ideas
#16

Hi Doppelganger,

After rereading your thread, did you mount the Zenith speakers in the two bottom left and right positions of the cabinet speaker board where 2 of the resonators belong? If so, you are already thinking like me. Miniature relatively good sounding amplifiers that run on 12V like the Kinter and Lepai units available on Amazon or eBay can be hidden in the cabinet, attached to a brace without ruining authenticity if removed. For a "period-authentic" mod, build either a stereo amp or 2 mono amps using a 6F5 and 6F6 for each channel and an 80 as a rectifier. Copy the amp section from the schematic of any period radio like the 37-60.

IMHO, this is merely an "addition" to the radio chassis, not a substitution for it. The chassis definitely should be restored because it is a piece of history and this is a rather High End (for Philco) set and while not a Zenith Stratosphere or a Scott Philharmonic, it is a very nice radio.

As stated before, having the person restoring the chassis to add an "Aux" or "Phono" input will add to your enjoyment of the radio by adding the ability to pipe "OTR" (Old Time Radio) programming into this chassis, not just a boombox or the speaker and amp combinations that I suggested.

There is not much on Shortwave from other countries, as the BBC, Vatican Radio, etc. do not "beam" signals to the US. This programming is available on the internet. Their shortwave assets are beamed to developing countries. You can search the internet for Shortwave radio stations that are available in the US. Many of these are Religious or talk Radio. Shortwave was the "Internet" of the 1930s and 1940s (and later)
where people gained firsthand knowledge of news in Europe that may not have been covered by US based news agencies or radio stations. During this time period, many Americans were either children of immigrants or immigrants themselves and were deeply interested (and likely deeply troubled) by the storm clouds of war developing there.

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
"Let us begin to do good"- St. Francis

Best Regards, 

MrFixr55
#17

My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". I always wondered about replacing those clarifiers with a midrange and a tweeter. Other than the crossover caps needed would the amp handle the additional load of new speakers? 8 ohm probably.

Again as a "addition " not a replacement. i would never permanently alter this radio.

Bill




Users browsing this thread:
[-]
Recent Posts
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM
Refinishing Ideas
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM
My Philco 37-116 Restore
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM
Zenith H725
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM
Philco model #20
AHH HA , I got it and can’t thank you fellows enough , when I changed the capacitors I took the advice and did not unsol...onlyrick — 02:24 PM
Zenith H725
Hello Ed, yes, I like letting projects run for few days to make sure they don't start acting up . Sincerely Richardradiorich — 01:03 PM
Philco 46-480 Electronic Restoration
I am almost finished with this restoration. All which remains is the power transformer. I cleaned it up some time ago, b...jrblasde — 12:41 PM
Philco model #20
I seem to recall in some TRF sets there being a Local/Distance toggle switch that removes the B+ from the first 24 rf tu...RodB — 09:46 AM
Refinishing Ideas
Hi Doppelganger, After rereading your thread, did you mount the Zenith speakers in the two bottom left and right pos...MrFixr55 — 09:39 AM
Philco model #20
Hi Rick, One other thing regarding volume on this set.  Make sure that the tube shield is in place.  this is that la...MrFixr55 — 08:22 AM

[-]
Who's Online
There are currently no members online.

>