Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need Philco 345 readable schematic
#1

I would like to know a source for downloading a readable schematic for a Canadian Philco model 345 code 122 radio.
I have schematics for models 45 but not for 345. Someone has been in the radio and put a 47mf cap in somewhere,and I need to see if I can find out what the right ones are.
Thanks Dan

   Living in Calgary Alberta
#2

Dan

I have the Radio College of Canada schematics on a DVD, which is sold by a collector in Canada.

I looked at the 345 schematic...hard to read, and you can't make out most of the part values, but I compared it against the USA 45 schematic and they are the same.

I'll send you a copy of this schematic if you want it, but like I said, the scan is not very clear.

--
Ron Ramirez
Ferdinand IN
#3

Thank you Ron.. I do have the same RCC disk and it is not very readable,that is why I put the request on the forum.
I will see if I can decipher the schematic.

   Living in Calgary Alberta




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 5804 online users. [Complete List]
» 2 Member(s) | 5802 Guest(s)
AvatarAvatar

>