1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Mystery Control labels
batterymaker
Member
***
Posts: 104
Threads: 11
Joined: Oct 2005
City: Indianapolis, IN
#1

12-04-2011, 08:16 PM
The labels on my Mystery Control looked pretty bad, so I decided to measure out and make a repro.

Scanned an original, measured it out, then used Paint Shop Pro to do the finishing touches.

I hereby donate an original. Print it at 18.5 mm for the length, and you'll have it.

The font you want to use is Alternate Gothic LT No. 2

Note from site admin: Sorry, but the photos which were attached to this post are no longer available.
Find
batterymaker
Member
***
Posts: 104
Threads: 11
Joined: Oct 2005
City: Indianapolis, IN
#2

12-04-2011, 08:17 PM
The other pic...old vs new....

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.
Find
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#3

12-04-2011, 08:50 PM
Excellent job! Icon_thumbup

Now the question is: Where can we obtain the Alternate Gothic LT No. 2 font?
--
Ron Ramirez
Ferdinand IN
Find
batterymaker
Member
***
Posts: 104
Threads: 11
Joined: Oct 2005
City: Indianapolis, IN
#4

12-04-2011, 09:04 PM
You can get it at myfonts.com
Find
Bob Andersen
Phorum Expert
*****
Posts: 797
Threads: 42
Joined: Dec 2008
City: Chicago, IL
#5

12-06-2011, 02:18 AM
Thank you !!! My control badly needs some new labels Icon_smile
Website Find
« Next Oldest | Next Newest »




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration