Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

US Gloritone
#1

Well, I finally did drag home a radio from Canton, OH tonight. Found a radio advertised as a 'US' radio on Craigslist a couple days ago for $44. I decided to check about it tonight and brought home a bit rough, but complete six-legged conole. Not very big with a six tube chassis. The tag inside claims it to be a US Gloritone model 3074. Basically the low end mate to my dad's 11 tube US Apex console. I'll try and post some pictures soon. Although they are very wobbly, at least the legs are intact.

No matter where you go, there you are.
#2

As I promised, a picture of the radio.[attachment=0]
Couldn't find a print for the radio, so my friend recapped it by reading and testing the old parts for reference. Did well up at his place, but the type 55 tube might be suspect. He's got miles of antenna, so it picked up well up there, but isn't very strong at all down here. I think I have a good 55 in one of my other radios, so might try a swap.

No matter where you go, there you are.
#3

Yes,
U.S. Radio & Television made the Gloritone and Apex sets plus a lot of the Airline sets for Monkey Wards. They were located in Marion, Ind. before being bought out by Grunow in '33' located in Chicago.
#4

John R Wrote:Yes,
U.S. Radio & Television made the Gloritone and Apex sets plus a lot of the Airline sets for Monkey Wards. They were located in Marion, Ind. before being bought out by Grunow in '33' located in Chicago.
Ah, so that's what happened to US Radio & Television. I also have a Mantola with the Apex 27 chassis in it from the 29-30 period. The Gloritone is working decently now, but the speaker is touchy and develops cone rub unless you have the volume and tone adjusted just right.

No matter where you go, there you are.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>