Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Keep the same thread, questions on 12 Caps please
#1

Ok you have seen this thread but looking for the value of the three caps on a late model 112 (47 output tubes). The three I'm looking for are the ones used in the tone control switch. Appreciate some help here. Not labeled on the schematic. Thanks for any help.
Jerry






Can anyone suggest a grill cloth that would be as close as possible to original for the above model? The one I just received has black! It looks old but doubt if it's right.
Thanks, Jerry

[Image: http://i303.photobucket.com/albums/nn129...2front.jpg]

[Image: http://i303.photobucket.com/albums/nn129...punder.jpg]

Can anyone tell me the value of caps in the three metal cans shown in the above? This is a later model 112 with the 47 output tubes. Awaiting better reading schematics from Chuck but hope to get a order in for caps.

Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#2

http://www.grillecloth.com/grillcloth/gallery.php

Pattern 42 or 64 - not original but better than black.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#3

Phlogiston Wrote:http://www.grillecloth.com/grillcloth/gallery.php

Pattern 42 or 64 - not original but better than black.
Those two patterns (42 and 64) look better in person than how they show up on-line. The actual samples don't have that red or orange tint..... at least that's how they show up on my monitor.

As our traditional sources of grille cloth dry up we may want to investigate other sources like the site Mike Koste mentions:

http://www.philcoradio.com/phorum/showth...p?tid=4038

http://www.philcoradio.com/phorum/showth...p?tid=4038

While some look like grillecloth.com patterns they might have a few different styles.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#4

The original pattern that was used in these sets was a stylized "P" that repeated itself, right side up and upside down, over the entire cloth.

This pattern was never reproduced.

I think S-G431F from Antique Electronics Supply would be a better choice, but that's just one man's opinion. This pattern is no longer available from Radio Grille Cloth Headquarters. This is a cross between the old patterns 1 and 2, a mixture of whiskey and copper colors.

--
Ron Ramirez
Ferdinand IN
#5

Thank you all for your suggestions. I will do a little looking. Jerry

A friend in need is a pest!  Bill Slee ca 1970.




Users browsing this thread:
[-]
Recent Posts
48-482 rear panel help
Hi Kettlechip and welcom to the Phorum. The back panel question is interesting. I have quite a few radios that use pow...MrFixr55 — 08:24 AM
Philco 46-480 Electronic Restoration
Not too much at all! :lol:  Sounds like you’re just dabbling into the hobby!jrblasde — 07:56 AM
Philco 46-480 Electronic Restoration
Hi Joseph, Fortunately, Ms. Fixr does not read my computer, or she would warn you against coming to me for sanity ch...MrFixr55 — 07:27 AM
48-482 rear panel help
There's a picture of one of the plastic covers in the following thread: I bought a full set of them in 2012 or so fro...klondike98 — 11:15 PM
Philco 46-480 Electronic Restoration
Good sanity check! You are correct—the first (as in, the most counterclockwise) position is for the push button presets....jrblasde — 11:05 PM
Philco 46-480 Electronic Restoration
Hi Joseph, First, verify that your band selector is in the correct position for what you want to do. I believe tha...MrFixr55 — 10:59 PM
Philco 46-480 Electronic Restoration
Got my replacement signal generator in the mail today! I was able to finish alignment of the IF section. I’ve got some t...jrblasde — 09:58 PM
The list of my radio & TV collection!
EdHolland. Glad you liked it. Thanks for the supportRadioSvit — 05:24 PM
The list of my radio & TV collection!
Great stuff, Peter thank you for posting.EdHolland — 04:06 PM
My Philco 37-116 Restore
The crack goes from almost the bottom of the tube to well past the fat part. It is an ST type tube. The filament is open...dconant — 10:04 AM

[-]
Who's Online
There are currently 315 online users. [Complete List]
» 2 Member(s) | 313 Guest(s)
AvatarAvatar

>