Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

And this is a what?
#1

So I payed to much for a 39-45 today ($100) Single mother 3 kids etc etc. But consoles are hard to find here in Vegas, and other than 1 tube shield base that was ripped out to put a GT tube in, it's all there.

But what caught my eye ( other than the young ladies chest Icon_redface ) was this thing screwed to the back of the cabinet. It has P/N 27-9184 cast into the back side and PHILCO ANT. GND and SET cast into the front. I'm assuming a lightning arrestor but don't know for sure. It's ceramic and potted like our favorite caps.

So what is it?


Attached Files Image(s)
   

John
Las Vegas, NV USA
#2

Yup, it's a lightning arrestor.

I don't know if you are married or otherwise involved, LASJayhawk; but if so, don't let your wife/significant other catch you looking at those things!

--
Ron Ramirez
Ferdinand IN
#3

Neat! But a funny location for a lightning arrestor. Maybe it was the "last chance" arrestor in case the one on the outside antenna failed.
#4

Ron, it's OK. My lady friend says I can look at all the lightning arrestors I want to look at! Icon_smile

Thought: feel free to use the pix if you want to add an accessory's category to the photo gallery. Would be kinda nice to have pix of things like that and the 40's antenna adapters, long wre kits etc for reference.

Also, since this thing has the correct grill cloth and doesn't look to bad and has the original finish, do you want a picture to update the gallery? If so let me know the format and how many pixels you want and I'll snap a few.

John
Las Vegas, NV USA
#5

Calling them "lightning arrestors"......

I wish I had thought of that. VERY arresting........yep!




Users browsing this thread:
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>