Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Found a 625 today
#1

Don't know if I paid too much for it but I don't think its in all that bad of condition. One electrolytic was replaced at one time I think, $55

[Image: http://i248.photobucket.com/albums/gg187...012001.jpg]

[Image: http://i248.photobucket.com/albums/gg187...012002.jpg]
#2

I think you did very well indeed for $55. Icon_thumbup

--
Ron Ramirez
Ferdinand IN
#3

Darn good shape! Ya dunn real good.
A rather hard model to come across too.

Icon_thumbup

Chuck
#4

So what is the difference between a 625 chassis and a 620? The wavelengths covered? I noticed that like a 620 it doesn't have a shadowmeter like a 630 would.
Regards
Arran
#5

It doesn't have a power transformer either, it's the AC/DC version of the 620.
Terry
#6

So take the usual isolation transformer
precautions and procedures with this hot-chassis set.

Chuck
#7

This isn't an AC/DC set, it uses a small, low profile power transformer. You can (barely) see the top of it to the left, behind the 80 tube, in Jim's second photo.

Arran, the 620 and 625 cover the same frequencies. There are differences in the circuitry, chiefly in the AVC circuit. The 625 also has a moving shadow mask behind the dial scale, with three holes that allow the greatest illumination only to the band in use.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 3996 online users. [Complete List]
» 2 Member(s) | 3994 Guest(s)
AvatarAvatar

>