Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dragged in another postwar Zenith.
#1

A co-worker and friend of mine talked to me a few days ago and wondered if I wanted a Zenith conole radio he had gotten cheap at a junk auction. Said he had been listening to FM on it without much issue. I went to visit him today and found it to be a decent little radio-phono console from the early 50's. Has an 8H20 chassis in it with the variable speed phonograph that I find to be neat. A little cash later and it was coming home. Other than the odd dial light being burnt out and a dirty band switch, it seemed to work fine on the radio. I pulled the chassis to clean up the switches and get the worst of the dirt blown off, only to find the one oil ringer cap near the power switch was blown clear in half! So, it will be getting recapped in the future. Kind of a shame as it was working rather well in spite of the bad cap. Cabinet is good except the top. Back top veneer is messed up. It should be worth a few extra dollars to put the insides right. I'll get some pictures of it once it is back together.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>