Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Unknown AA5 set... any guesses?
#1

[Image: http://i261.photobucket.com/albums/ii66/...resize.jpg]

Got handed this one from my father-in-law. What I have on it, thus far--

9 inches wide, 6 inches tall (excluding handle) and 5 inches deep.

Tubes in the chassis are 50L6GT, 35Z5GT, 12Q7GT, 12K7 GT, and 12A8G.

This lineup matches several Emersons, Dewald Pierce-Airos and some Electrohome Dominions, but the chunk o' decal under the bakelite (?) grille doesn't match anything like those labels.

A plate on the back of the chassis reads

"Licensed under patents of
RADIO CORPORATION OF AMERICA
GENERAL ELECTRIC COMPANY
WESTINGHOUSE ELECTRIC & MFG CO.

and associated companies and under Hazeltine & Latour patents by

HAZELTINE CORPORATION
to the extent shown by notice within."

and serial no. CX-422866.

I'd question the cabinet's originality, but the plastic dial cover doesn't have any extra sets of holes where it had been stapled, nor does the cardboard between the speaker and cabinet, plus the cabinet has mounting holes for (presumably) the back cover.

The dial face has "717-3" on it, out of view unless the chassis is pulled.

I know it's a long shot, but... any guesses?
#2

I'm thinking General Radio and Television.

Mark
#3

Yep. Very similar to this one.

[Image: http://www.radioatticarchives.com/images..._Toppo.jpg]

Larry
#4

CX serial number might be Climax, one of the many independent Chicago brands that isn't well documented.
#5

Very similar to the General (X)A5 series; only difference is the dial face. A brief look at the schematic looks like the right critter, too. Another contender is the 591. I just haven't found any with the same dial face.

I checked out Climax a little bit--boy, you're right, there isn't much out there. Radiomuseum.org didn't have any 5-tube schematics that the tube lineup matched. They had some pictures of cool cabinets, though Icon_smile




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>