Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Just finished RCA globetrotter
#1

I thought I would post some photos of my latest finished radio.
It's an RCA 12 tube model A-33 Globtrotter. The cabinet work was easy. I recapped the radio,and changed the 1 meg resistor for the eye tube and it works..Sounds real nice with a phone hooked up..
It still has a slight hum between stations but with my knowledge of electronics it will have to do until I learn more. Here are the photos.

[Image: http://i318.photobucket.com/albums/mm405...A008-1.jpg]

[Image: http://i318.photobucket.com/albums/mm405...Medium.jpg]

[Image: http://i318.photobucket.com/albums/mm405...Medium.jpg]

[Image: http://i318.photobucket.com/albums/mm405...Medium.jpg]



[Image: http://i318.photobucket.com/albums/mm405...012001.jpg]
#2

Wow, that looks fantastic! Great job!!

- Geoff
#3

Looks great.
#4

Beautiful job.
#5

That cabinet takes my breath away. Beautiful!
#6

Dan, you have a knack for finding sets with very good-looking, stylish, beautiful cabinets. Good job! Icon_thumbup

--
Ron Ramirez
Ferdinand IN
#7

Beautiful set! Nice job with it! I'm impressed to the point that I have added it to my "bucket list!" Icon_thumbupIcon_thumbup
#8

Your satin finish is the perfect touch. Just spectacular.

Keep one hand in your pocket
#9

Thank you for the comments. I run across these radios at garage sales and flea markets and by word of mouth. The cabinet part is easy but the chassis is another story,so I keep reading ''The Elements of Radio''
I also put a few adds on Kijiji with good response.
Here is my latest find..It is a RCA and the model is ''Master''
I picked it up at the local flea market for $30.00. It has now been racapped and polished up. Before and after photos


[Image: http://i318.photobucket.com/albums/mm405...edium2.jpg]
[Image: http://i318.photobucket.com/albums/mm405...Medium.jpg]

[Image: http://i318.photobucket.com/albums/mm405...Medium.jpg]




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4211 online users. [Complete List]
» 1 Member(s) | 4210 Guest(s)
Avatar

>