Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PHILCO FLIP_TOPS
#1

I would like to find a 116px or a 610pf, 630pf, 635pf, 640pf all flip top radios, but all were sold in low volumes.
Did any make it into collections?
Any around?
#2

The models you mention are radio-phonographs.

I once saw the remains of a 610/630/635/640PF cabinet at AWA in Rochester some years ago. There was nothing inside - even the mounting board for the phonograph was gone - and the cabinet was in very bad shape. It was actually sitting next to a trash can. I looked at it, thought about it, realized it would take more work than I had time for, and left it there. I wonder if anyone rescued it.

--
Ron Ramirez
Ferdinand IN
#3

If anyone runs into a 116px, even in that very poor condition I would be interested.

Thanks
#4

I saw one in a 2nd-hand store in Brady, Tx a yr or so ago. Next time Im down that way will see if it is still there.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 5394 online users. [Complete List]
» 1 Member(s) | 5393 Guest(s)
Avatar

>