Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-d10a dynamic reproducer
#1

Anyone know where I can get a dynamic reproducer for a 47-1209 ?
I have tried several sites but no luck
#2

Correction 46-1209
#3

This question comes up from time to time.

The original "dynamic" (magnetic) cartridge has not been manufactured in several decades. To complicate matters, the originals were often damaged by owners who stuck steel needles into the cartridge, in spite of being warned in Philco literature of the period not to do so, destroying the cartridge.

Steel needles have a slightly larger diameter than the proper stylus for this cartridge,,,just large enough to damage it beyond repair.

And, once damaged, the cartridge cannot be fixed.

An alternative is to use a modern magnetic cartridge, connected to run in mono instead of stereo, with a 78 rpm stylus. Tracking weights may be an issue, but this can be overcome.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 4801 online users. [Complete List]
» 1 Member(s) | 4800 Guest(s)
Avatar

>