Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Iveyline Radio from Hickory, NC
#1

Got an interesting 1920s set yesterday.

Nameplate says IVEYLINE//Manufactured By// The Southern Toy Company// Hickory, NC

The tube lineup from left to right is: UX199, X171A, MU20, MU20, CX300
The X171 is a Gold Seal tube, and the UX199 is in an adapter which in turn is mounted in the socket.

Unfamiliar with the MU-20 tube. One of them has on it's base Davin Amplifier//Type MU-20// Fil Volts 6// Fil Amps 1/4

   
   
   
   
#2

Neat looking set. that MU-20 tube is an odd one never heard of it before either.

Have you tried to power the set yet?

-Keith
#3

Still trying to figure it out. I don't think the tube complement is right, the UX199 and x171 seem out of place before the Daven three tube amplifier.

I am thinking that 01As should go there. But I am not real spun up on these older 20s sets, so I want to figure everything out before I plunge madly ahead.
#4

Very neat acquisition, Tom! Icon_thumbup

I do think, however, that someone just stuck some tubes in the front end of your radio - it should not have a UX-199 and a 71A, but two 01A tubes. The 199 requires a lower filament voltage than the 01A.

I've heard of the Daven tubes. Somewhat rare, I believe. If your set has an entire Daven three tube amp, that alone may well be a real "find." In that case, the radio should probably use a 201A RF amp, 201A or 200A detector, then the three stage audio amp.

--
Ron Ramirez
Ferdinand IN
#5

Yes, that is what I am thinking! The UX199 is in an adapter, too, and I have never heard of an X171 being used as a detector.

BTW the X171 is a gold seal tube, also relatively rare. Where the MU6 tube should go in the output portion of the Daven amp is a CX300 tube.

Maybe I can trade someone the gold seal X171 for a MU-6...??
#6

I have heard of UX171As being used as power output tubes in 1920s battery sets, usually installed after the fact, but not as a detector. The 199 is wrong, with or without an adapter, and there isn't much advantage to using one that I can think of since they have a 3 volt filament I think. MU-6 sounds like an old military tube designation, but then again there was no rhyme or reason to how a company labeled their tubes in those days.
Regards
Arran
#7

A fellow on ARF sent me the following link:

http://books.google.com/books?id=zd8DAA ... or&f=false

In the 1928 article there is information about using the 171 tube as a detector.

Additionally, he noted the presence of a rheostat with the UX199 and stated that it was common to use the 199 as an RF tube in sets like this one due to their low inter-electrode capacitance. The rheostat would drop the V for the 199's filaments.

Very interesting...!!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
That silver can capacitor is an aluminum electrolytic. You should replace it with an aluminum electrolytic with the valu...RodB — 11:46 PM
Philco 42-345 Restoration/Repair
Thank you Rodb and Gary for helping with clarification on these capacitors. Other than the Tiny 630volt one I'm not sure...osanders0311 — 10:17 PM
1949 Motorola 5A9M
Hello All; I found the CMB41L down in the basement, it is definitely a 1950-51 model, the capacitors have date codes ...Arran — 07:48 PM
Philco 42-345 Restoration/Repair
Hi, all the caps I order, other than the electrolytics, are of the 630V rating. No worries on it being too high, and no ...gary rabbitt — 05:46 PM
Philco 42-345 Restoration/Repair
Hi, there's a lot to consider when designing these circuits so you shouldn't have a lot of concern when replacing caps. ...RodB — 02:03 PM
Philco 42-345 Restoration/Repair
I have ordered and received new caps for this radio and hope I've ordered the correct ones. I tried matching them to the...osanders0311 — 11:35 AM
Philco newbie with P-1891-WA console questions
Hello Jeff , Far as the Electrolytic capacitors go here is a list of parts. that will work . I like using Nichicon and...radiorich — 09:50 PM
Philco newbie with P-1891-WA console questions
Well, I've been stumped at trying to get the first of 11 electrolytic capacitors. I got a schematic and have a list of t...Jeffcon — 07:54 PM
Model 80 Antenna Issue?
Thanks Gary and Rod.  I also found an article in the Philco Repair Bench under Service Hints and Tips, about installi...Hamilton — 12:32 PM
Model 80 Antenna Issue?
Hello Hamilton, here is a little information found in our Philco Radio Library at the bottom of the Home page. Hope it ...GarySP — 11:28 AM

[-]
Who's Online
There are currently no members online.

>