Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

And, finally...a Scott Philharmonic!
#1

A few weeks ago, I noticed someone had posted over at the E.H. Scott forum, wanting to sell an E.H. Scott FM Philharmonic in a Warrington cabinet.

The price was right, so I dipped into some savings and bought it.

[Image: http://www.philcoradio.com/images/phorum...786e6a.jpg]

It looked pretty nice to me, but when I saw the serial number, I knew I had to have it.

[Image: http://www.philcoradio.com/images/phorum...37b72a.jpg]

Notice the serial number starts with my initials (RR)?

I have never used a shipping service before, but since the set was in southeastern Kansas, I used Craters & Freighters for the first time. I have to say, they did a good job - the set arrived here undamaged.

[Image: http://www.philcoradio.com/images/phorum...b2fd77.jpg]

The set has no tweeters, and it is apparent that it never had any - there are no screw holes where they would have mounted. The woofer has a large "whizzer" cone.

All of the photos above were taken by the gentleman who was selling it for his neighbor.

I'll take some photos of my own and post here, after I clean this set up and reassemble it.

--
Ron Ramirez
Ferdinand IN
#2

Great findIcon_thumbupIcon_thumbupIcon_thumbupIcon_thumbup

Ron, if you keep on you may have to add a roomIcon_biggrin

Steve

M R Radios   C M Tubes
#3

If that's the same firm tht sent my My Hammond amd Tone cabinet from Colorado Springs to New York, can't say enough positive about them. It's a niche market, and not cheap, but a few of them know what they are doing. Good of you to mention reliable movers.

Got to downsize soon myself, its time, so need good current moving references too. Please post specifics and contact information.
#4

Icon_sick

Joe Bratcher near Louisville, KY
#5

OH..MY...GOODNESS!!!!

Icon_clapIcon_thumbupIcon_clapIcon_thumbupIcon_clapIcon_thumbup

That is a swell collection of Scotts, Ron!!!!
#6

Sharp, Boss!!! Icon_thumbup

Mike
#7

Ron, what a great find. Looking forward to the receiver pictures as well. Love to see it after a little dusting. Don't know how you have the time for this stuff. Looks like the chrome should clean up well. If you don't like it, send it out here!
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#8

Very nice find Mr Scott, 'er, I mean Ron.
I like the extra nice touch on the serial number plate lettering. meant to be.

Bruce
#9

Congratulations Ron Icon_thumbupIcon_thumbupIcon_thumbup

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#10

What a beautiful set, Ron!!!

CongratulationsIcon_clapIcon_clap

Gene
#11

You're gonna like it. I had one years ago (chassis and speakers only), but the chromiumwas bad, and I wasn't up to stripping the chassis and re-donng them. I sold it.
#12

More photos.

First, the amp/power supply chassis after a good cleaning and polishing:

[Image: http://www.philcoradio.com/images/phorum..._00033.jpg]

Front view of the woofer, showing the whizzer cone:

[Image: http://www.philcoradio.com/images/phorum..._00035.jpg]

and a back view of the woofer:

[Image: http://www.philcoradio.com/images/phorum..._00034.jpg]

The entire set was quite dirty, with lots of mouse droppings. Even more trash was found at the bottom of the speaker pedestal...including the remains of a long-dead mouse. Icon_eek

Debbie and I cleaned the cabinet up, and I rubbed it down with Howard's Restore-A-Finish.

Now, a look in the back of the set, with the woofer and amp/power supply in place:

[Image: http://www.philcoradio.com/images/phorum..._00037.jpg]

The speaker mounting board has holes cut out for tweeters, but this set never had any - note the absence of screw holes:

[Image: http://www.philcoradio.com/images/phorum..._00038.jpg]

Now, a look at the back of the set with everything in place:

[Image: http://www.philcoradio.com/images/phorum..._00043.jpg]

I'll clean and polish the upper chassis later.

A close-up of the dial and knobs:

[Image: http://www.philcoradio.com/images/phorum..._00044.jpg]

And, finally, the reassembled Philharmonic as it now sits in our living room:

[Image: http://www.philcoradio.com/images/phorum..._00045.jpg]

--
Ron Ramirez
Ferdinand IN
#13

Sharp!!!Icon_thumbupIcon_thumbupIcon_thumbupIcon_thumbupIcon_thumbup

Happily back in Illinois..not.
#14

Another unfortunate illustration of Scott's infamous flash chrome plating, if only they had triple plated it like the car manufacturers did back then. The cabinet on this set was perfectly fine, no lifting veneer, warpage, or other signs of moisture and water damage but the chrome plating still has rusted through and bubbled off in places.
For some reason most of the Philharmonics seem to be housed in Warrington cabinets, same with the Phantom series, it most have been the default cabinet option when these were sold. By the way, did anyone notice the pattern in the grille cloth?
Regards
Arran
#15

Well, Arran, in this case, the rust spots on the chrome weren't entirely Scott's fault. It doesn't help when mice have been hanging around your Philharmonic. Icon_eek And I think we all know what mouse urine can do to a chassis, especially one that wasn't chrome plated. In this case, I think the chrome plating saved the amp/power supply so that it still looks decent. I think if it had not been chrome plated, it would have already rusted through in places.

I am still amazed that none of the connecting cables were chewed, nor the speaker cone - even though I found the remains of a long-dead mouse inside the speaker pedestal.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>