1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Rare Philco find but a mystery ?
rocklandman
Junior Member
**
Posts: 38
Threads: 17
Joined: Aug 2011
City: Nanuet, NY
#1

10-18-2012, 03:03 PM
Sorry for the delay in putting this up have been busy.
Picked this up on Sun. and it is a bit of a mystery?
It is a rare 200x radio, and has a radio spec tag and chassis for a 201x chassis? But It was also pointed out to me that there is also a small tag on it that says 200x?????? It even has the original back cover.

Buy the way it is not for sale, someone very dear to all of us here on this forum is getting.

Rock


Attached Files Image(s)
                   
Find
rocklandman
Junior Member
**
Posts: 38
Threads: 17
Joined: Aug 2011
City: Nanuet, NY
#2

10-18-2012, 03:04 PM
more pics


Attached Files Image(s)
       
Find
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#3

10-18-2012, 03:45 PM
My opinion: I believe this set is a 201 chassis in a 200X cabinet, and it was done by Philco at the factory. I would guess this set was built at the point of transition from model 200 to 201, and Philco had a few 200 cabinets left over, so out went the first few 201X sets in 200X cabinets.

It wouldn't be the first time Philco had pulled a stunt like this...leaving us scratching our collective heads decades later.

Whoever is getting that set is one lucky fellow and, no doubt, a very happy fellow as well!
--
Ron Ramirez
Ferdinand IN
Find
TA Forbes
Deviate Emeritus
*****
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
#4

10-18-2012, 10:29 PM
Definitely agree!! There are numerous documented cases of this that can be found here in the Phorum.

I have a 38-2650 in a model 37 tombstone cabinet, and also have a 1935 model 16X with a five-band '34 model chassis.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 3653 online users. [Complete List]
» 1 Member(s) | 3652 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios