Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Schematic for a 14B - Never mind
#1

Does anybody have a clear schematic for a 14B?

It's done.

Thanks
#2

I'll bet Chuck does. I need to get one too. The one on NA really bad. From the looks of it it ought to be a great playing set. One rf amp, two if amps, and three stages of audio... Plus a shadowgraph. I've got the 14 modern version.
Terry
#3

I'm about 3/4 of the way through this one now. by the time I find a ledgable schematic, I won't need it. I'll let you know in the morning how well it works.

Interesting that a lot of the dogbone resistors in this one seem to have drifted down rather than up, or they were lower to start with and did not drift (much).

Yes, a 42 driving 2 more in PP. Should be loud, anyway.
#4

Yes, Phlogiston, I have an original Model 14 Service Bulletin No. 176, in my archives,
and all published Production Change Notes from Philco. Shadow Meter info as well.

Regards,
Chuck
#5

Thanks guys, but it is all done, just takes a couple of hrs longer without a good schematic. It is hard to tell which contacts are used in the Bakelite caps without one.

It is a very nice radio. Picked up lots of stations with only a 18" antenna.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently no members online.

>