Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What $140 Bought Me This November
#1

I consider myself very lucky this month. For the meager sum of $140 I have acquired the following radios:
1. Another 9s262 Zenith looks to be a basically unmolested set. with ALL of it's original knobs.
2. A Zenith 6s52 needing some case help, with ALL of it's original knobs.
3. A Sparton 1268 with photochromatic dial. Case is in overall nice condition, with ALL of it's original knobs. The dial is broken but is still usable. There is flaking on the back side and I am wondering if there is any method to be able to stop it from going any further. I know these dials are pretty much unobtanium, but you never know..............

[Image: http://i1185.photobucket.com/albums/z345...2front.jpg]
[Image: http://i1185.photobucket.com/albums/z345...52dial.jpg]
[Image: http://i1185.photobucket.com/albums/z345...52rear.jpg]
[Image: http://i1185.photobucket.com/albums/z345...s52top.jpg]

[Image: http://i1185.photobucket.com/albums/z345...Z9s262.jpg]
[Image: http://i1185.photobucket.com/albums/z345...9s262a.jpg]
[Image: http://i1185.photobucket.com/albums/z345...h9s262.jpg]
[Image: http://i1185.photobucket.com/albums/z345...e9s262.jpg]

[Image: http://i1185.photobucket.com/albums/z345...8front.jpg]
[Image: http://i1185.photobucket.com/albums/z345...268top.jpg]
More pics in part 2



Gene
#2

And this thread answered my question about the Sparton Cabinet!

I could not tell that it was the Selectronne model when I looked at the chassis photos. That is a VERY good radio!! Sparton, along with several other manufacturers, offered sets that featured 45 tube output long after they had made the switch to the 6V filament tubes. There was (and continues to be today) many who felt that the older triode gave a clearer, cleaner sound.

Personally, I believe that the 6A3 and 6B4G triodes from that period were just as good as the 45, and offered more power out.
#3

I wished I lived in a place like that where $140 buys one at least one unmolested 9S262....
#4

You and me both Morzh! Nice score for a hundred forty bones!

One cannot forbid people to be idiots....all one can do is try not to be one. -Morzh




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>