Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Has anyone seen this coin-op?
#1

This is listed on craigslist for $95. Not working, no key. I'm sorely tempted, but a little leery. He says he has a half dozen of these pulled from the Mapes Hotel-this is the best one.
It looks like a Setchell Carlson conversion, but I haven't seen one like it.
Think it's worth the price?
[Image: http://highsierrahosting.com/photos/coinop.jpg]
[Image: http://highsierrahosting.com/photos/coinop2.jpg]
[Image: http://highsierrahosting.com/photos/coinop3.jpg]

Time flies like an arrow, fruit flies like a banana
#2

Looks to be intact. I'm not sure what they are worth, but you can bet any coin op radio is rare considering that most were probably junked with the notels they were in. I've only seen one in the flesh my whole lofe.

No matter where you go, there you are.
#3

Upon closer perusal, I see something missing on this set. There's a bracket on the side, which presumably held a pillow speaker, which is not in evidence. That could sour the deal. Anyone have a source for vintage pillow speakers?

Time flies like an arrow, fruit flies like a banana
#4

Why not ask the seller if he has a pillow speaker from one of the others?
#5

I told him I'd call in the morning, and that's a question I'll definitely be asking.I suspect the answer will be negative, but there's always hope...

Time flies like an arrow, fruit flies like a banana
#6

I used to think that coin operated radios were something unusual but they seem to come up more often then you would think. One thing to keep in mind is that they were usually overbuilt using steel or heavy duty wooden cabinets. This example looks like it uses the same chassis as one of the Setchel Carlson "frog" models, what that means in terms of rarity I don't know. To be honest I think $94 is a little steep for something like this, especially if it's DOA, when you get down to it you still have a five or six tube AC/DC set inside.
Regards
Arran
#7

I talked to him this morning. He thought the metal bracket that holds the speaker when not in use was the antenna. He had no idea that there was a pillow speaker involved. He doesn't remember seeing any around, but he's making a trip to the 'barn' in a couple of days and search around. He's also going to count the number of these radios he has. Maybe I'll try to cut a package deal with him ... Sounds like this barn is chock full of stuff. Could be a good episode for 'American Pickers'!

Time flies like an arrow, fruit flies like a banana
#8

Check your PMs, concerning a coin op.
Don
#9

Don, indulge my ignorance, what do you mean by the PM's?

Bill
#10

He means your "Private Message" box here at the Phorum. Icon_smile

No matter where you go, there you are.
#11

No message there.

Time flies like an arrow, fruit flies like a banana




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 4100 online users. [Complete List]
» 2 Member(s) | 4098 Guest(s)
AvatarAvatar

>