Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help Identifying radio
#1

Hi Everyone - I am inheriting a radio and I would really like to identify it so I can begin restoring. Unfortunately it looks to be missing a plate on the front and there are no labels that I can find so it's been tough so far. Based on what I've found in the gallery and through my own research I believe it to be Philco Model F possibly...

Does anyone recognize this type of radio?

Thanks!


Attached Files Image(s)
                   
#2

Looks like a 1933 Airline Radio. Can you post a clear pic of the chassis and tell us how many tubes there are and what kind they are?
#3

Nice, I hadn't heard of those yet. I just updated the pics above, do those help? I believe there are 4 tubes. Thanks!
#4

Based on what you said, i did find a very similar looking radio here:

http://www.radiomuseum.org/r/montgomery_...e_119.html

I inspected the radio it does look like there used to be a few pieces over the speaker area that were broken off. the major difference though between mine and the one in the link above is the presence of a fourth knob. The radio in the link has one extra than what mine has.
#5

It has ten tubes, there are more tubes inside the aluminum cans. It's too bad that the dial escutcheon is missing and the speaker grille is broken out. It should be possible to find another escutcheon with some searching, as for the grill that could be replicated but you would need to make a pattern from the grille in an identical cabinet.
Regards
Arran
#6

i'm keeping my fingers crossed that my family has the dial escutcheon somewhere as they thought it was on there originally when we got it. as for the grillle pattern, how would you recommend I go about finding another to make the pattern from?
#7

Most likely made by Wells-Gardner, who was a major supplier of radios for Montgomery Wards (Airline). They used that same dial on other models, so you might get lucky and find an escutcheon that fits.

Tim KA3JRT




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 5140 online users. [Complete List]
» 1 Member(s) | 5139 Guest(s)
Avatar

>