Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Who's in Michigan that would like a GE Colorama CHEAP?
#1

http://www.ebay.com/itm/VINTAGE-GE-AM-SW...3381964937

I'd give my 200 MHz dual trace scope for one of these....
#2

Tell you what.. if someone will give this a good home, I'll PAY for it and you can just pick it up. I just don't want to see this go to being a bar or a digital entertainment center... not at that price.
#3

If I had any plans to go near Michigan I would get it myself, I like G.E sets. With regard to good candidates to turn into something else, this Philco 16X cabinet with the plastic Hong Kong cathedral stuffed into the front would be a good candidate for that, or as a veneer donor, or for burning.

http://www.ebay.com/itm/Antique-Philco-M...RTM1303753

Regards
Arran
#4

Nice looking set! I'd buy it and I'm cheap!! But alas it's too far away.
Terry
#5

hey Micheal Dennis...this radio is just a little south of you! Actually, the set is in very southwest lower Michigan...closer to Indiana or Illinois folks. Take care all. Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#6

Brenda, is it something you cannot get to? I know a couple of collectors out that way, i can send them the link.

Paul

Tubetalk1
#7

I have no way to personally get to anything. I'm at an overseas US military installation, so my only way to get radios is via USPS/MPS. Give the link to whomever you like, I just want to see this set go to someone who will restore it rather than use it for some crazed steampunk or modernization scheme.
#8

I'm North of Detroit. These GE sets are nice, though not one of my holy grails.

Is the price on the eBay auction what you want for it. or fill mr in with the details.

Might be well to PM me, and we can talk.
#9

Not my set. I just want it to go to someone who will appreciate it, since I have no way to get it myself. These Coloramas are fairly rare, and very nice sets.
#10

Didn't sell and is relisted. I have a trashed cabinet and would buy this if it was closer.




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4104 online users. [Complete List]
» 2 Member(s) | 4102 Guest(s)
AvatarAvatar

>