Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-610
#16

+1 what Arran says. If I'm goingf to spend a considerable amount on a radio, I prefer natural wood grain every time! Take care. Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#17

I have many sets in cabinets that are mezza-mezza but play well and had a clean chassis to work with. Though a nice shelf Queen is pretty too. Where I like to listen to the radios I live with the the water stains, cigarette burns, maybe refinish when really poor....
Good Hunting.

Paul

Tubetalk1
#18

I have a 37-610 ..Just because its only five tubes do not even think for a minute that you should not purchase to put into your collection. It is super picks up stations from all over. I love mine would not give it up. My faux wood grain has two very little scratches. One of the very first radios I ever purchased. Keith Park did the electronic resto thats why it works go good. I am still trying to get the handle of doing one myself.
#19

I don't believe Arran meant to slam the 610!

I have owned several 610s and 37-610s, and agree that they do very well for a five-tuber. Philco made some swell five-tube sets!

But relatively speaking, for 200 dollars you can get a lot of radio. From a standpoint of sensitivity, selectivity, and quality volume, the 610 does not perform as well as other models with more tubes/features that you could get for 200 dollars. In fact, I got my 37-116 for 200, and my 38-116 for less, and both are in nice shape.

The 610/37-610 was closer to a base model set, albeit a good playing one.

The 200 dollars spent on the 37-610 was doubtless due to it's condition. For many folks that is what they are looking for.
#20

$200.00 dollars is a whole lot to pay for that radio... but is a good performer for a five tube radio.
#21

No I wasn't bashing the 37-610 in and of itself, I just wouldn't think of paying $200 for one just because the faux grain is in nice shape. Because these sets were a near entry level model there were a lot of them produced. While the faux grain is bad on a lot of them it's not like it's anywhere near impossible to find one where the grain, if not pristine, is at least restorable like the front panel on Bob's 38-62.
Regards
Arran
#22

+1 Icon_thumbup




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM
two videos to watch VHS and history of TV
Hello Every, Here are a couple videos right up my alley VHS and the history of Television . history of VCR VHS Hi...radiorich — 02:13 PM
Made mistake & did not label connection
You haven't given us the model number of the set so I looked up the 6A8 pin assignment. Pin 8 is the cathode and pin 7 i...RodB — 01:19 PM
Made mistake & did not label connection
Happy Thanksgiving all! I have made a real bonehead mistake this time. Hope someone can help.  I am trying to determi...georgetownjohn — 12:51 PM
New Philco Repair Bench
Apparently there is a new Philco Repair Bench found at https://philcoradio.com/repairbench/ When I try to go to order a ...dconant — 12:00 PM
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM

[-]
Who's Online
There are currently 3499 online users. [Complete List]
» 2 Member(s) | 3497 Guest(s)
AvatarAvatar

>